Despite the advantages of grain silos, not every farmer can afford such a structure, since it is expensive. Medium-sized farms are increasingly using pneumatic frame structures, including inflatable hangars .
Such a granary involves placing crops on a prepared floor. Construction is carried out using modern practices and safe materials, which has a positive effect on the quality of the structure and benefits the farmer.
Ground grain storage should only be used for a specific crop, since the calculation for sunflower is not relevant for oats. The products also differ in the requirements for the microclimate that needs to be organized indoors. It is also important to fully work out the procedure for loading and unloading raw materials.
The latter directly affects the capacity of the granary, since the space equipped with grain transport systems will be twice as large as its analogues, where there are no mechanisms for automating loading operations.
During the calculation, it is important to take into account the likelihood of combining one space for storing different crops. In this case, it is necessary to distinguish between two types of products, and the same should be done with harvests collected in different years.
When storing grain using the floor method (in bulk), it is not recommended to form mountains whose wall height is higher than 2.5 meters. This limitation is due to safety regulations, as the pressure on the hangar increases significantly.
The unfavorable impact of such rules on the useful volume of the granary can be reduced by using fenders or “false” walls, the height of which is 2.5-3 meters. With their help, more culture can be loaded into the same hangar.
For the convenience of calculations, special calculators are used that allow you to specify the main parameters for obtaining data:
The latter allows you to find out the mass of grain per 1 m3 in tons. You can get information about this for a specific crop in an agricultural directory.
The parameter (k) is used in the following formula: m=V*k, where m is the mass of grains, and V is the volume (working) of the storage. The last value directly depends on the length and width of the structure, and the third variable is the height of the embankment near the wall, which is most often 2.5 meters.
This is one of the most simplified formulas that allows you to understand what mass of a certain grain can be loaded into a hangar under given conditions. More detailed calculations include the angle of repose of the grain - the specific indicator depends on the type of product.
Accurate data can be obtained during design and estimate work, when a grain storage plan is drawn up. Only at this stage, taking into account absolutely all the nuances, can you find out the final volume of the structure.
Modern inflatable hangars can accommodate grain whose mass is measured in thousands of tons. To do this, it is important for the customer and the performing company to determine the parameters of the structure sufficient for the required volumes.
There is no need to worry about the large size of such structures, since in a 1000 m2 project the length of the walls is 20 and 50 meters. And this is enough to accommodate 2 thousand tons of grain, if poured to a height of 2.5 meters. Wheat was included in the calculations; for sunflower, the mass indicator was 2 times less.
The example project also uses technological elements necessary for the full use of the granary, among them there are square swing gates with a side length of 4 meters. These are adjustable parameters, so they can be easily changed at the request of the customer, as well as provide for different ways of opening them or positioning them relative to the center of the structure.
An inflatable hangar is a pneumatic frame structure made of polyester fabric, modified with a special protective impregnation. The structure rests on the surface and protects the grain from external factors due to excess air pressure inside its structure, which gave the building its name.
Excess pressure is controlled and maintained at the required level using electric blowers that can operate even from a household network. They must be constantly on, so uninterruptible power supplies are provided in advance.
Since the structure is inflated inside the walls, the farmer can keep the gate wide open around the clock. Open sashes of windows or other technical structures will not create any problems.
What other features do such structures have:
The HANGAR MAKER company is engaged in the construction of pneumatic hangars for agriculture, including grain storage. We have our own production, so we accept individual orders. You can submit an application for an initial consultation through the appropriate section on the website.